RF·Tools

Inductors

The solenoid is computed exactly, through Nagaoka’s coefficient, rather than by Wheeler’s formula, which is good to a percent and only for coils that are not too short. Besides the inductance you get Q, the self-resonance and the length of wire: without those a number in microhenries says little.

Type

Leave “solve for turns” empty and what you entered is analysed. Fill in an inductance and you get a fractional turn count: rounding it off is the tuning.

What you get

Inductance4.05 µH
Reactance at the frequency178.2 Ω
Quality factor642 (upper bound)
Resistance: DC0.0276 Ω
Resistance: at the frequency0.2775 Ω
Wire length1.26 m
Self-resonance81.6 MHz
Self-capacitance0.939 pF
Nagaoka coefficient0.7699
Winding pitch1.50 mm
the wire is thicker than six skin depths (0.025 mm at this frequency): the middle does nothing, and Q does not grow the way you would like
Q is computed from the skin effect alone. The proximity effect — adjacent turns pushing the current out of each other — is not in the model, and it is expensive: on a close-wound coil the real Q comes out one and a half to three times lower. Treat the figure as an upper bound