RF·Tools

Dividers and hybrids

Three devices out of nothing but quarter-wave sections: a Wilkinson divider with a resistor between the arms, a branch-line hybrid with its 90° phase difference, and a rat-race giving sum and difference. The dimensions are worked out for your substrate, and the S-parameters come from those very dimensions by nodal analysis — so you see the copper loss, and you see the hybrid stop being a hybrid at the second harmonic.

Device

Layout

FR-4, 1.6 mm Download SVG Download DXF
λ/43λ/4421310 mmrf.akzami.com

The digits at the leads are port numbers, and the ports are not interchangeable: feed a rat-race at the wrong port and the sum becomes the difference. Junctions and tees are not in the drawing; they get trimmed in the board editor.

S-parameters

One curve each for the split, the input match and the isolation. The bandwidth is not set by the through path, which holds up widely, but by the isolation and the match.

Dimensions

Section What it is Z, Ω W, mm L, mm
λ/4 three λ/4 sections 70.7 1.54 17.5
3λ/4 the long section 70.7 1.54 52.4

The resistor is a chip part soldered straight across the arm ends: there are no separate pads in the export, the arm copper is the footprint.

Ports

1sum Σ
2output 2
3output 3
4difference Δ

What you get

Split-3.21 / -3.30 dB
Loss beyond the split0.20 dB
Input match45.6 dB
Isolation45.1 dB
Phase difference0.0°
−20 dB isolation bandwidth2.06…2.74 GHz (28 %)
Board size41.3×26.3 mm
Substrateεr 4.40, h 1.60 mm
the model knows nothing about junctions: tracks of different widths meet at a node and the tuning drifts down by a few percent — leave room for trimming