RF·Tools

Microstrip filters

A filter made of copper alone: stepped impedance, radial stubs, quarter-wave stubs, coupled lines, hairpins or a comb. The dimensions are computed for the substrate you name, and the response is computed from those very dimensions, with dispersion and loss. So the plot shows the real insertion loss and the spurious passbands the prototype knows nothing about. Hairpin and interdigital filters are solved with a multiconductor model: there every resonator couples to two neighbours at once, and a chain of pairs cannot describe that.

Type
 
 

Low-pass needs one frequency only. The refinement fits the dimensions to the response of the layout itself: the textbook calculation misses the cutoff by tens of per cent. “Spread the stubs” keeps neighbouring sectors from merging into one piece of copper: the impedance of the line between them is lowered until the gap is wide enough — the same inductance takes more length on such a line. The board gets longer for it, and the match is usually a little worse.

Layout

FR-4, 1.6 mm · size 32.6×22.4 mm Download SVG Download DXF
RS1L1RS2L2RS35 mmrf.akzami.com

The copper is to scale; the circle is a via to ground. Steps and tee junctions are not modelled, so expect to trim the lengths a little in your PCB editor. Every capacitance is a pair of sectors on both sides of the line, a “butterfly”. A pair and not a single sector: a lone stub pulls the current to one side and adds the inductance of its own junction to the capacitance, while in a symmetric pair that cancels out. Ctrl and the wheel, or a pinch, zooms; drag to move; a double click fits it back. The SVG and DXF carry the copper, the vias and the board outline — no dimensions, no scale bar; the sizes are real, in millimetres. The site address sits on a separate layer (MARK in the DXF) so that it cannot end up as copper on import — delete it if you do not want it.

Response of this layout

Download .s2p

A cascade of real line sections with dispersion and copper and dielectric loss — not the ideal prototype.

Dimensions

Element What it is Z, Ω θ, ° W, mm S, mm L, mm
RS1 shunt capacitance, butterfly — 65 13.8 — 6.49
L1 series inductance 90 43 0.87 — 10.2
RS2 shunt capacitance, butterfly — 65 17.3 — 8.20
L2 series inductance 90 44 0.87 — 10.4
RS3 shunt capacitance, butterfly — 65 14.0 — 6.58
feed system-impedance line 50 — 3.02 — —

For a radial stub (RS) the columns carry the sector angle, the overall width of the butterfly 2·r_out and the radial extent r_out − r_in. The inner radius r_in is the same for every stub — half the width of the narrow line: 0.43 mm.

What you get

Passband loss0.18 dB
Return loss≥ 25.4 dB
−3 dB cutoff2.04 GHz
Spurious passband7.16 GHz, -0.8 dB
Board size32.6×22.4 mm
Substrateεr 4.40, h 1.60 mm

The dimensions were refined against the response of the structure. Before refinement the return loss was 13.7 dB.

a spurious passband at 7.16 GHz (-0.8 dB) — distributed filters always have one; if it matters, follow the filter with a lumped-element low-pass
the εeff under the sector is taken from a line of the same average width: under a wide sector the field is closer to that of a parallel-plate capacitor, and the approximation costs a few per cent in cutoff frequency